Connecting The Water Supply Hose(Option); Positioning The Drain Hose - Samsung Q1044A Owner's Instructions Manual

Installing the Washing Machine

Connecting the water supply hose(Option)

1. Remove the adaptor from the water
supply hose.
2. First, using a '+' type screw driver,
loosen the four screws on the adaptor.
Next, take the adaptor and turn part(b)
following the arrow until there is a 5mm
gap.
3. Connect adaptor to the water tap by
tightening the screws firmly.
Then, turn part (b) following the arrow
and put(a) and (b) together.
NOTICE
After completing connection, if water leaks from the hose, then repeat the same steps. Use
the most conventional type of faucet for water supply. In case the faucet is square or too big,
remove the spacing ring before inserting the faucet into the adaptor.

Positioning the drain hose

The end of the drain hose may be positioned in three ways:
Over the edge of a sink
The drain hose must be placed at a height
of between 60 and 90 cm. To keep the drain
hose spout bent, use the supplied plastic hose
guide. Secure the guide to the wall with a
hook or to the faucet with a piece of string to
prevent the drain hose from moving.
ln a sink drain pipe branch
The drain pipe branch must be above the sink siphon so that the end of the hose is at least
60 cm above the ground.
ln a drain pipe
Samsung recommends that you use a 65 cm high vertical pipe; it must be no shorter than 60
cm and no longer than 90 cm.
c
a
b
SAMSUNG Washing Machine Owner's Instructions 5
4. Connect the water supply hose to the
adaptor. Pull down part (c) of the water
supply hose.
When you release part (c) the hose
automatically connects to the adaptor
making a 'click' sound.
5. Connect the other end of the water
supply hose to the inlet water valve at
the top of the washer.
Screw the hose clockwise all the way in.