Samsung InfoRanger SCM-100R User Manual page 16

Getting Acquainted
2.2 Default Switch
After the cable modem is installed, cable service provider will authorize and
customize the cable modem settings by downloading software image to the
cable modem's memor y. The original factory default settings are stored in pri-
mary memory. Factory default settings will never be changed.
If you experience difficulty using cable modem, please call your cable service
provider immediately. Your service representative will determine if the cable
modem needs to be reset to factory default. The cable modem can be reset to
factory default by pressing this switch.
Please use the Default Switch ONLY when instructed by an authorized cable
service representative or by a Samsung technical support engineer.
2.3 Display Switch
This display (or virtual power) switch serves two functions: (1) to turn off
the LEDs and (2) to disconnect the Ethernet interface, which isolates the
modem from the PC.
When this display switch is off, the modem is still powered, interfaced to the
cable, and is on standby.
The modem in this state can send to, and receive data from, the head-end, but
cannot communicate with the PC through the Ethernet port.
In this state, the LEDs are off. There is no indication of modem operation.
2.4 Reset Switch
The modem can be reset by pressing this switch.
After reset, the modem will automatically reconnect with the cable provider.
2.5 Ethernet Activity LED
This green LED flashes when transmitting or receiving data through the
Ethernet port.
9
3