Cable Installation; Figure 2-9 Cable Connections - Comtech EF Data CSAT-5060 Installation And Operation Manual

5 to 25 Watt Model C-Band Transceiver
Single-Thread Installation
2.4.3 C I
ABLE NSTALLATION
Refer to Figure 2-9.
Care shall be exercised in cable installation. Install the cables using the most direct route and
secure with clamps and ties. Avoid all sharp bends.
Cable connectors used in outdoors application shall be sealed to avoid leakage, particularly, N-
type connectors. Moisture can seep into junctions at the plug end of the connector, between the
fixed and movable parts, and where the cable connects to the connector. Signal attenuation and
possible loss of signal can occur in the presence of moisture. All cable junctions shall be sealed
with a self-amalgamating tape, such as 3M, Type 23 Scotch Self-Amalgamating tape, or
equivalent, including military style (MS) connectors.
The Downconverter RF input connector is wired to supply DC voltage to an LNA. This
voltage is capable of damaging any test equipment connected to the connector. Do not
connect test equipment to this connector without a coaxial DC block between the
WARNING
connector and the test equipment.
C/S
TOP VIEW
J2
RF, OUT TX
RF, IN RX
BOTTOM VIEW
J3
AC POWER
J1
IF IN
GND
J6
IF OUT
J5
J4
COMM
EXT REF
J7
2-9
Revision 1
MN/CSAT506025.IOM
Figure 2-9. Cable
Connections