Samsung YP-60 Quick Manual

YP-60 Quick Guide

Location of Controls

Heart Rate Measurement Sensor
Display
MENU/
Loop Repeating Button
Move to Track/
Speed Search Button
Sports Function Button
USB Cable
Connection Port
ENC Jack
Reset Hole
If the device won't respond even after pressing the buttons,
reboot it by pressing the Reset Hole with a pin.
Turning Power On and Off
Power On :
Press and hold the button to turn on the power.
Power Off :
Press and hold the button to turn off the power.
Playing Music Pausing Music
Press the button. Press the
Playback starts. While in Pause mode, briefly press
1
Earphone Jack
Hold Switch
Play/Stop/Pause
On/Off Button
Volume Button
ENC/NAVI.
Button
button to pause playback.
again to resume playback.

Connecting the USB cable

Before connecting the yepp to PC, make sure to install yepp Studio.
1
Connect a USB cable to the USB port on the computer.
2
Connect the opposite end of the USB cable to the
USB cable port on the right side of the yepp.
If you disconnect the USB cable from your PC while
implementing a command or initializing during
USB driver installation, your PC may not function correctly.
3
The USB driver is installed with a message saying that it
is searching for a new device. You may not see the
display screen during installation.
Go to the device manager to check that
installation has been successfully completed.
4
Upon installation of the USB driver
"SAMSUNG YP-60" will appear in the
[Start] [Settings] [Control Panel]
[System Properties] [Device Manager].
2