Table of Contents
Advertisement
Installation Instructions
Read completely, then follow step by step.
• The appliance shall be installed in accordance with national wiring regulation.
• If a power plug isn't to be used, provide a circuit breaker between power source and the unit, as following
picture.
Main Power source
Circuit Breaker
Use a circuit breaker
or time delay fuse.
Select the Best Location
To prevent vibration and noise, make sure
A
the unit is installed securely and firmly.
Install the unit where the sunlight does not
B
shine directly on the unit.
There should be no obstacle, such as a
C
fence or wall, within 50cm from the back of
the cabinet because it will prevent heat
radiation of the condenser.
Restriction of outside air will greatly reduce
the cooling efficiency of the air conditioner.
Install the unit a little obliquely outward not to
D
leak the condensed water into the room
(about 5 ~ 10mm or 1/4 bubble with level).
CAUTION: All side louvers of the cabinet must
remain exposed to the outside of
the structure.
GASKET
COOLED
AIR
8
FENCE
AWNING
HEAT
RADIATION
5~10mm
Over 50cm
1/4 Bubble
Level
Advertisement
Chapters
Table of Contents
