Advertisement
Safety Precautions
Note:
This device complies with Part 15 of the FCC Rules. Operation
is subject to the following two conditions: (1) this device may
not cause harmful interference, and (2) this device must accept
any interference received, including interference that may cause
undesired operation.
This equipment has been tested and found to comply with the limits
for a class B digital device, pursuant to Part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against
harmful interference in a residential installation. This equipment
generates, uses and can radiate radio frequency energy and, if
not installed and used in accordance with the instructions, may
cause harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to
radio or television reception, which can be determined by turning
the equipment off and on, the user is encouraged to try to correct
the interference by one or more of the following measures:
Reorient or relocate the receiving antenna. Increase the
separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit different from
that to which the receiver is connected.
Consult the dealer or an experienced radio/technician for help.
FCC Caution: To assure continued compliance, follow the
not expressly approved by the party responsible for compliance
could void the user's authority to operate this equipment.
AMP Air Conditioning
EN 5
Precautions for Use
Do not use in the following places:
Where humidity/oil/vibration is excessive, the unit will be exposed
to direct sunlight or near a heat source, or condensation is likely
to occur.
(Otherwise, failure may be caused.)
Where excessive noise is present.
(Otherwise, malfunction may be caused.)
ECONAVI sensor is for indoor use only.
Do not damage or scratch the surface of the sensor section.
(Otherwise the sensor may become unable to detect properly.)
Do not apply pressure to the sensor section.
(The sensor section may get damaged.)
Do not clean with benzine, paint thinner, or chemically treated wipes.
(Discoloration or deformation may occur.)
If the sensor section is dirty, gently wipe it with a dry cloth.
If the sensor is very dirty, soak a cloth in water-diluted neutral
detergent, wring it thoroughly, and use it to wipe the sensor
clean. After that, gently wipe it with a dry cloth.
EN 6
EN
FR
ES
DE
IT
PT
GR
RU
UR
KZ
www.ampair.co.uk | sales@ampair.co.uk
Advertisement
