Advertisement
BATTERY OPERATION
Open the battery compartment at the rear of the unit and insert 6 batteries, observing the
polarity diagram indicated inside the compartment, and close the compartment. To switch from
AC power to battery power, disconnect the AC power cord.
Battery Replacement
Batteries should be replaced when the volume decreases or the sound distorts.
Notes on batteries
• Do not mix batteries of different types or new batteries with used batteries.
• The batteries cannot be exposed to excessive heat such as sunshine, fire or the like.
• Please respect the environment when disposing of used batteries.
• To prevent leakage, always remove the batteries from the device when it is not used for an
extended period.
AUDIO CONTROLS
Press
to turn the unit on. When the unit is on, press
source: FM, AM, CD, AUX IN.
LISTENING TO THE RADIO
MANUAL SEARCH
1. Press
to select FM or AM.
2. Press repeatedly
or
to find your station.
3. Adjust the sound level with
or
FOR OPTIMAL RADIO RECEPTION:
FM: Extend and position the telescopic antenna.
AM: Rotate the unit horizontally.
AUTOMATIC SEARCH
Press
to select FM or AM.
Press and Hold on
or
for about 2 seconds to start the search. The automatic search
function locates stations whose signal is strong. Press again
Note:
Stations with weak signals can be searched manually.
The sound is automatically muted during search.
RADIO PRESET STATIONS
1. Select a station manually or automatically with
2. Press once
, "P01" blinks on the display for a few seconds.
3. Press
or
to select a preset number.
4. Press
again to store the radio station on the selected memory number.
5. Repeat steps 1-4 to store other stations.
Note: When you store a station in a memory number already occupied, the existing station is
automatically erased.
LISTENING TO PRESET STATIONS
Press
button to select a preset station.
again to select your listening
.
or
to continue the search.
or
.
- 5 -
LISTENING TO DISC
1. Press
button to turn on the unit.
2. Open the CD door.
3. Place the CD with label side up inside the CD compartment and close the CD door.
4. Press
button to select CD function.
5. After a few seconds, the total number of tracks and "CD" icon will appear on the display.
To:
- Read your CD: Press once
- Pause Playback: Press again
- Resume playback: Press again
- Permanently stop playback: Press
- Search forward or backward: Press and hold
- To skip to the next or previous track: press
DISK ERROR
Note: If the disc is dirty, damaged or unreadable, or if the disc is placed upside down, "NO" will
appear on the display. If this occurs, clean the disc, insert the disc correctly or try another disc.
If you encounter CD playback problem, either of the following ways may help:
1. Turn off the unit. Disconnect the AC power cord from AC outlet and reconnect it again.
2. Clean your CD disc.
REPEAT PLAYBACK
Repeatedly press
to select one of the following playback modes. Track Repeat an
Repeat All.
TO DISABLE THE REPEAT PLAYBACK
Press
repeatedly until the repeat mode indicator disappears from the display. The
repeat function is automatically canceled at the opening of the door of the CD or the shutdown
of the unit.
PROGRAM PLAYBACK
1. Insert the disc with the label facing up, into the compartment and close the CD door.
2. Press
.
3. Press
.
4. Select the desired track with
or
5. Repeat step 4 until the end of your programming.
6. Press
to start playback. This PROGRAM function is automatically canceled when
opening the CD door or shutdown of the unit.
Note:
CD up to 20 programs.
or
or
then press
to save the program in memory.
- 5 -
Advertisement
