Page 4
Multi-Frässchablone Montage Die Profi le A und B (1.1) sind wie folgt zu montieren: - Profi l B wird mittels des Nutensteins in die seitliche Nut (1.2) von Profi l A geschoben. Dabei müssen beide Skalen nach innen zeigen (1.3). - Die Profi...
Page 5
Tilt protection The tilt protection (4.3) is inserted in the copying ring for large surface cuts (4.1). The height differential between router table and workpiece is thus compensated, allowing tilt-free guidance of the router on the template (4.2). The tilt protection can be used with copying rings of diame- ters 24, 27, 30 and 40 mm.