initialization
WIEGAND OUTPUT SETUP
You can transfer data of the card read by SSA-S2000 in the 26-bit Wiegand output format.
Enabling this function will disable the TTL output and the chime bell sound.
1.
To enable the 26-bit Wiegand output, you must manipulate the switch panel (SW1 and SW2) on the rear of the
product.
2.
See the table below to make adjustment as needed.
❖
Changing Output
SW1 #1
SW1 #2
ON
OFF
OFF
ON
J
In the 26-bit Wiegand output mode, you can not initialize the product by short-circuiting cables.
INITIALIZATION
If you have the Master Card registered, you can use it to initialize the device.
1.
Present the Master Card to the device.
9
2.
Press the
button twice and press
3.
The system will restore the factory default settings with all LED indicators
blinking.
M
Initializing the system will lose all data.
If the product works abnormally, use initialization to restore the default settings.
16_ Initialization
SW2 #1
SW2 #2
Orange line with white stripes
ON
OFF
OFF
ON
Wiegand Data0
.
ENT
Brown line with white stripes
TTL Output
Chime Bell Output
Wiegand Data1