Installation; Before Applying Power - KAR-TECH MINI REMOTE User Manual

INSTALLATION:

1.Refer to the wiring chart for
wiring connections.
3.When installing the unit, the
main power should run from the
battery, through a 20 amps fast
blow fuse, to a power switch or
relay; then into the receiver unit.
For best results connect the
receiver main power connections
to the auxiliary terminal of the
ignition switch, PTO switch, or
ignition relay. Use 18 gauge or
heavier wire.
4.All connections
properly insulated to protect
MINI REMOTE
against shorts.

BEFORE APPLYING POWER:

1.Check
polarity.
2.Check
possible shorts before connecting
remote control to output devices
(i.e., valves, relays) by checking
each mating pin terminal.
3.Read the rest of this manual.
must be
power and ground
wiring harness
2
for