Pairing the Remote Control
A process that enables two-way communication between the TV and the remote control when their MAC addresses match after the TV
saved the MAC address of the remote control and vice versa.
Auto Pairing
❑
An automatic pairing method that completes the pairing of the TV and the remote control internally without user intervention when a
user operates the remote control after purchasing a TV with a RF remote control.
■
If Auto Pairing does not work, refer to the 'Manual Pairing'.
When the TV is turned off (Standby mode)
■
1
Press the POWER(P) button on the RF remote control.
■
The remote control enters pairing mode.
2
The TV that receives the Power command is turned on.
■
The TV enters pairing mode. Pairing mode is maintained
until pairing is complete.
3
Pairing mode is completed.
■
A buzzer goes off.
When the TV is turned on
■
1
Press any key on the RF remote control.
■
The remote control enters pairing mode.
■
After paring is complete, the key pressed by the user
transmits the corresponding command to the TV.
■
The time taken to complete the pairing and to send the
command is less than 1 second.
2
The TV is already in pairing mode.
■
A TV, the paring of which is not completed, remains in
pairing mode while the TV is turned on.
3
Pairing mode is completed.
■
A buzzer goes off.
You can pair the TV and the remote control so that the remote control only
■
controls the TV.
1
Plug the TV power plug into the power outlet.
■
Turn the TV power switch off.
2
Press the PAIRING button on the remote control.
■
Use a sharp object to press the button.
■
Keep a distance of less than 3 feet (1 m) between the TV and the remote control.
3
Press the POWER(P) button on the front panel of the TV. The TV is turned on and Pairing with the remote control is
automatically completed.
4
Press the remote control buttons to check if the remote control is properly paired.
■
If the remote control does not work, attempt the pairing process again.
■
If the remote control does not work even after the above measures have been taken, press the RESET button, and
replace the batteries.
Manual Pairing
1