Installing The Display On The Wall Attachment Panel - Samsung SPK4215M Owner's Instructions Manual

Installing the Display on the Wall Attachment Panel:

See the drawing of the wall attachment panel shown in page 14 to check for
1
the stability of the wall where the PDP is to be installed. If the wall is not
enough strong to support the PDP, strengthen the wall before installation.
Fix the wall attachment panel on the wall using bolts as shown in the following
2
figure: Fixing bolts must protrude from the wall appox. 0.6 inches.
Using the wall attachment panel, you may adjust the angle of the display from
3
0 to 20 degrees. The angle can be set in 5 stages with 5 degrees of distance
each using the angle control holes on the sides of the panel.
When the angle
has been set to 5
degrees.
Angle control holes
When the angle
has been set to
15 degrees.
5 degrees of tilt
10 degrees of tilt
15 degrees of tilt
20 degrees of tilt
Continued...
When the panel
hasn't been tilted.
No tilt
15