Hummer H-240AURA Manual page 7

Connecting the water cooling kit
Motherboard RGB control
B) If your motherboard has any RGB
lighting system, plug the RGB Hub
adapter into the motherboard and make
sure the pin with an arrow is connected
to the 12 V pin on motherboard.
Internal RGB controller features:
MODE:
Press this button to switch the lighting into a dynamic mode.
- Blinking mode: 7 color cycle / Green / Blue / Red / Cyan / Lime / Purple / White
- Breathing mode: 7 color cycle / RGB cycle / Green / Blue / Red / Cyan / Lime / Purple / White
COLOR:
Press this button to switch the lighting into a static mode. There a lot of different colors for choice.
SPEED/BRIGHT:
- When the lighting is running in dynamic mode, this button will change the speed of the ligthing effect.
- When the lighting is running in static mode, this button will control the brightness of the light.
- Hold this button to turn off the LED lighting. Press it again to turn on the lighting.
A) Connect both fans and the pump connector to the RGB Hub adapter (16).
Internal RGB controller
C) If your motherboard doesnt has any
RGB lighting system, plug the RGB hub
adapter into the internal RGB controller
in the way showed in the picture
above. Then connect the Internal RGB
controller to a PSU connector.