Setup And Configuration - Honeywell LYRIC T6 Manual

Setup and configuration

After power up, SETUP is displayed on the thermostat's screen.
Touch to begin.
setup
Once setup is completed go to the advanced menu to change application specific changes.
BINDING
The Lyric T6R Smart Thermostat wireless kit comes pre-bound from the factory.
The binding operation described below is only required if:

The Lyric T6R thermostat or Receiver box is replaced.

The Lyric T6R thermostat or Receiver box has incorrect or no binding data stored.
- Thermostat will indicate the Alert message: NO RECEIVER BOX BINDING
- Receiver box status LED remains green blinking (no communication from thermostat)
- Receiver box status LED does not light up (not bound).
To bind/rebind
Note: When the Receiver box has been bound before first press with a small pin
the pinhole for approximately 3 seconds to reset the binding. All LED's will
flash amber for a moment.
1. Put the Receiver box into binding mode by pressing the button for 3 sec.
- The LED will flash amber
2. Enable binding on the thermostat:
- Enter the advanced menu by pressing the
- Navigate to BINDING
- Select BIND and the signal will be sent
3. When binding is successful:
- Thermostat will show SUCCESS
- Receiver box status LED will show green
When binding is NOT successful:
- Thermostat will show FAILED
- Receiver box will exit binding after 3 min.
RF communication might be too far or is blocked due to wrong location of the
Thermostat or Receiver box. Try to move closer or re-locate and re-bind again.
Select language.
button for 5 sec.
8
LYRIC T6 SMART THERMOSTAT
Set clock format, time
and date.
Touch to finalise setup.
( to setup using the Lyric
App is currently unsupported)
LYRIC-T6-EN0H 8603 NL01 R1216