Table 2-4 Mounting Procedure; Figure 2-4 Mounting Method - Honeywell UDC2300 Product Manual

Installation
Mounting Method
Before mounting the indicator, refer to the nameplate on the outside of the case and make
a note of the model number. It will help later when selecting the proper wiring
configuration.
Mounting Procedure
Step
1 Mark and cut out the indicator hole in the panel according to the dimension information
in Figure 2-3.
2 Remove the screw cover and loosen the screw on the front of the indicator. Pull the
chassis out of the case.
Orient the case properly and slide it through the panel hole from the front.
3
4 Remove the mounting kit from the shipping container and install the kit as follows:
•
Install the screws into the threaded holes of the clips.
•
Insert the prongs of the clips into the two holes in the top and bottom of the case.
•
Tighten both screws to secure the case against the panel.
•
Carefully slide the chassis assembly into the case, press to close, and tighten the
screw. Replace the screw cover.
10
Panel

Figure 2-4 Mounting Method

Table 2-4 Mounting Procedure

Action
UDC2300 Indicator Product Manual
20752
10/00