Remote Control Overview; Insert Remote Control Batteries; Basic Connections - Samsung DVD-V85K Instruction Manual

00090A DVD-V85K/XTC-Eng1 9/17/02 11:31 AM

Remote Control Overview

1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19

Insert Remote Control Batteries

10
Page 10
1 POWER
2 AUTO TRACKING/TRACKING +/-
20
3 AUDIO
4 SHUTTLE <</>>
21
5 MODE, REPEAT
22 6 KARAOKE SEARCH
7 ZOOM
23 8 3D SOUND/100+
9 DVD, VCR
24
10 KARAOKE
25
11 VOLUME /
26
12 REWIND, SKIP BACK
13 STOP
27
14 RECORD
15 UP
28
16 LEFT
17 SETUP/ENTER
29
18 RETURN
30 19 TITLE, SPEED
20 OPEN/CLOSE
31
21 0-9
22 TV/VCR
32
23 DISPLAY
33
24 ANGLE
25 CLEAR
34
26 SCREEN FIT
27 INPUT SEL.
28 DIGEST, F.ADV/STEP
35
29 CH /
30 FAST-FORWARD
36
SKIP NEXT
31 DISC MENU
32 PLAY/PAUSE
33 RIGHT
34 DOWN
35 MARK, SEARCH
36 SUBTITLE, TIMER
• Remove the battery cover by pushing down on the thumb tab and
sliding the cover.
• Insert two 1.5V "AA" batteries as shown, paying attention to the correct
polarities (+/–).
• When finished, slide the cover until it clicks back into place.

Basic Connections

In this section, you will connect the DVD-VCR to your television.
NOTES:
• Advanced Connections are covered in Appendix A.
• Even if you plan to use the S-Video or Component Video Outputs,
you MUST connect the DVD-VCR to your television with
either the standard RF or the Line Out connection. This
enables you to operate the DVD-VCR setup menus.
1 Connect Antenna/Cable to DVD-VCR
Connect the RF antenna cable from your indoor/outdoor antenna or
cable wall outlet to the IN (FROM ANT.) jack on the back panel of
the DVD-VCR.
2 Connect DVD-VCR to TV
Choose one of the following methods to connect the DVD-VCR to
your TV:
RF Connection
Connect the supplied RF antenna cable from the OUT (TO TV) jack
on the back panel of the DVD-VCR to your television's Antenna
I n p u t .
NO T E : Check the channel to connect DVD-VCR to your
television's Antenna Input; See page 20.
Line Connection
Connect an RCA-type audio/video cable (red, white, yellow) from
the LINE OUTjacks on the back panel of the DVD–VCR to your
television's Line In jacks. Use red for right audio, white for left
audio, and yellow for video.
NOTE: It is recommended that you use the Line Connection if your
TV is equipped with RCA jacks.
3 Plug In DVD-VCR
Connect the DVD-VCR power cord to wall outlet. Don't press any
buttons on the DVD-VCR or remote during auto setup. "AUTO"
blinks while the DVD-VCR runs an auto setup procedure, where it
will automatically search for all active channels.
4 Turn On DVD-VCR
Press the POWER button on the remote control or on the
DVD–VCR's front panel.
5 Turn On TV
Press the POWER button on your TV.
6 Set TV to Channel 3, 4 or Line
Be sure to use the same channel you selected in Step 2. If you
used the Line Connection, set your TV to its Line Input.
1
From Antenna or Cable
2
2
To TV's Antenna Input
4
4
11