Samsung NV7 OPS User Manual page 12

a C onnecting to a Power Source
Number of images and battery life : Using the SLB-0837
Still image
Battery life Number of images
Approx. 75 MIN Approx. 150
Using the fully charged battery,
Auto mode, 7M image size,
Based
Fine image quality, Shot to shot interval
on the : 30Sec.
following Changing the zoom position between
shooting
the Wide and the Tele after every shot.
conditions Using the flash on every second shot.
Using the camera for 5 minutes and
then Powering it off for 1 minute.
The specified shooting capacity can be affected by using the OPS function.
These figures are measured under Samsung's standard conditions and shooting
conditions and may vary depending on the user's methods.
INFORMATION
Important information about battery usage.
When the camera is not used, turn off the camera power.
Please remove the battery if the camera will not be used for long periods.
Battery can lose power over time and are prone to leaking if kept inside the
camera.
Low temperatures (below 0°C) can affect the performance of the battery
and you may experience reduced battery life.
Battery will usually recover at normal temperatures.
During extended use of the camera, the camera body may become warm.
This is perfectly normal.
Movie
Recording time
Approx. 80 MIN
Using the fully charged
battery
Based 640X480 image size
on the 30fps frame rate
following
shooting
conditions
You can charge the rechargeable battery (SLB-0837) by using an SAC-45 KIT.
The SAC-45 consists of the AC adapter (SAC-45) and the USB cable (SUC-C2).
When the AC adapter and the USB cable are assembled, it can be used as an
AC cable.
Using the SAC-45 as an AC charger
: Insert the AC adapter into the USB connector.
When the AC adapter is inserted, it can be used
as an AC charger.
Using the SAC-45 as an USB cable
: Remove the AC adapter from the USB connector.
You can transmit data with a PC (p.71) or charge
the battery.
CAUTION
In the following cases, the battery may not be charged.
When using the USB cable that was not supplied with this camera. Use the
supplied USB cable.
When using a USB hub. Connect the camera to the PC directly.
When other USB devices are connected to the PC. Disconnect the other
USB devices.
When the USB is connected to the USB port located on the front of the
computer. Use the USB located on the back of the computer.
If the USB port of the PC doesn't meet the Power output standard (5V, 500mA),
the camera may not be charged.
11