Samsung DIGIMAX L60 User Manual page 75

FAQ
When the DirectX 9.0 or later is not installed
Install the DirectX 9.0 or later
1) Insert the CD provided with the camera
2) Run the windows explorer and select the [CD-ROM drive:\ USB
Driver\DirectX 9.0] folder and click the DXESETUP.exe file.
The DirectX will be installed. Visit the following site for downloading the
DirectX.http://www.microsoft.com/directx
If a PC (Windows 98) stops responding while the camera and PC are connected
repeatedly
If a PC (Windows 98) is turned on for a long time and the camera is
connected repeatedly, the PC may not recognise the camera. In this case, re-
start the PC.
If a PC connected with the camera stops responding while Windows is starting.
In this case, disconnect the PC and the camera and Windows will start.
If the problem happens continuously, set the Legacy USB Support to disable
and re-start the PC. The Legacy USB Support is in the BIOS setup menu.
(The BIOS setup menu differs from the PC manufacturers and some BIOS
menus don't have Legacy USB Support) If you can't change the menu by
yourself, contact to the PC manufacturer or BIOS manufacturer.
If the movie clip can't be deleted, removable disk can't be extracted or an error
message displays during the file transfer.
If you install only the Digimax Master, the problems mentioned above
occasionally happen.
- Close the Digimax Master program by clicking the Digimax Master icon on
the Taskbar.
- Install all the application programs included in the software CD.
(You must install the Movie clip codec)
74
MEMO