Using The Remote Control Backlight Buttons; Connections; Connecting Vhf And Uhf Antennas - Samsung BN68-01691A-02 User Manual

Using the Remote Control Backlight Buttons

TV VCR DVD STB
Use this feature in dark surroundings and when you are unable to see the remote control buttons clearly.
TV VCR DVD
1. Press the ON/OFF light button.
Pressing the
➣
When ON, the button backlight is turned on for a moment.
➣
Pressing a remote control button when the remote control is on turns the button backlight on for a moment. If
➣
you touch or move the remote control and the motion is detected by the sensor of the remote control, the button
backlight will be turned on for a moment.
Since there is a vibrating device inside the remote control, shaking the remote control will result in a sound
➣
generated by the device.
The button backlight will not be turned on when the remote control is turned off.
➣

Connections

Connecting VHF and UHF Antennas

If your antenna has a set of leads that look like the diagram to the right, see "Antennas
with 300 Ω Flat Twin Leads" below.
SET RESET
If your antenna has one lead that looks like the diagram to the right, see "Antennas with
75 Ω Round Leads".
SET RESET
If you have two antennas, see "Separate VHF and UHF Antennas".
Antennas with 300 Ω Flat Twin Leads
If you are using an off-air antenna (such as a roof antenna or "rabbit ears") that has 300
Ω twin flat leads, follow the directions below.
1.
Place the wires from the twin leads under the screws on a 300-75 Ω adapter (not
supplied). Use a screwdriver to tighten the screws.
2.
Plug the adaptor into the ANT IN terminal on the back of the TV.
Antennas with 75 Ω Round Leads
1.
Plug the antenna lead into the ANT IN terminal on the back of the TV.
Separate VHF and UHF Antennas
If you have two separate antennas for your TV (one VHF and one UHF), you must combine the two antenna signals before
connecting the antennas to the TV. This procedure requires an optional combiner-adaptor (available at most electronics
shops).
1.
Connect both antenna leads to the combiner.
2.
Plug the combiner into the ANT IN terminal on the bottom of the rear panel.
STB
ON/OFF light button toggles between ON and OFF.
English - 9
ANT IN
ANT IN
UHF
VHF
ANT IN
UHF
VHF