Advertisement
Replacing the lamp
T urnthepoweroffanddisconnecttheprojectorfromthepoweroutlet.
Pleasecontactqualifiedservicepersonnelforchangingthelamp.
y To reduce the risk of electrical shock, always turn the projector off and disconnect the power cord
before changing the lamp.
y To reduce the risk of severe burns, allow the projector to cool for at least 45 minutes before
replacing the lamp.
y To reduce the risk of injuries to fingers and damage to internal components, use caution when
removing lamp glass that has shattered into sharp pieces. Before replacing the lamp, clean the
lamp compartment and dispose of cleaning materials. Be careful of sharp edges in the lamp
compartment. Wash hands after lamp replacement.
y Only ViewSonic certified lamps are tested with this projector. Use of other lamps may cause
electrical shock and fire.
y Wear working gloves during lamp replacement.
y Unplug projector power at least 10 minutes before replacing the lamp.
1. Turn the power off and disconnect the projector from the wall socket. If the lamp is hot, avoid burns
by waiting for approximately 45 minutes until the lamp has cooled..
2. Loosen the screw then remove the cover from the projector.
2-1
2-2
CAUTION
y Donotturnthepoweronwiththelampcoverremoved.
y Donotinsertyourfingersbetweenthelampandtheprojector.Thesharpedgesinsidetheprojector
maycauseinjuries.
1
Advertisement
