Edelbrock E-Street 2 Quick Reference Manual

1. Power on the tablet by pressing and holding down the
power button until the screen turns on.
2. If the tablet isn't adequately charged, or isn't turning on,
connect a USB charger to the MicroUSB slot.
3. Find the Edelbrock E-Tuner App Icon on the Home
screen. Select the icon to launch the E-Tuner App. NOTE: If
you are supplying your own Android device and need to
download the E-Tuner App, do so now from the Google Play
Store. To do so, follow the Downloading the E-Tuner App
section on the back of these instructions.
From the E-Tuner Home page, select Setup Wizard to
4.
launch the E-Tuner Wizard.
5. Power on the ECU by turning the ignition to the "ON"
position and press the Pairing Settings button. Do NOT
start the engine until prompted to do so!
6. On the Pairing Settings screen, verify that an EFI Rz ECU
is listed and highlighted in RED. Press OK to continue.
If an ECU is not listed, press the ECU Search icon to search for
the ECU. Select the EFI Rz ECU and press OK to pair.
7. The title bar across the top of the screen will flash yellow,
indicating that the device is attempting to communicate with
the ECU. If the ECU is already paired, E-Tuner will take you to
the Setup Wizard screen. Proceed to Step 8.
NOTE: If you encounter a popup screen requesting a Bluetooth
Pairing Request, you must manually pair the ECU to the Android
device. To do so, enter the Pairing Code found on the ECU label
and select OK. Proceed to Step #8 once the ECU has been
successfully paired. NOTE: If the pairing fails, you may have to
turn the ECU off and back on and then repeat this procedure.
8. The screen below will show how the system is currently
configured. Select Start the Wizard to continue. NOTE: You
will need a screwdriver and a timing light to complete the Wizard
Setup.
9. Use the "-" and "+" keys to enter the displacement of your
engine. Click the Right Arrow to proceed.
10. Select the proper camshaft profile. Please refer to the cam
card included with your camshaft, if applicable. Click the Right
Arrow to proceed.
11. Select the 58 PSI fuel system option. This includes both a
Return-Style fuel system as well as the Edelbrock Fuel Sump
System.
12. If you have installed the optional Ignition Control Kit, select
Yes to enable the Ignition Control feature. Otherwise select NO
to keep it disabled. Click the Right Arrow to proceed. NOTE:
Additional Ignition Control components are required to utilize
the Ignition Control feature.
13. The Wizard will automatically start loading a base map.
When the map is finished loading, you will be prompt to turn the
ignition off for 10 seconds and then back on. Click OK to close
the popup window and then click the Right Arrow to proceed.
14. Read the important warning then select the Check Mark
next to My Engine is Ready to Start. Do NOT start the engine
or drive the vehicle until prompted to do so.
Step 15 ONLY applies to applications using
Ignition Control. If you have not installed the
additional Ignition Control components, skip
to Step 16.
15. Connect a timing light, remove the air cleaner (if installed)
and loosen the distributor clamp.
a. Click the Set Base Timing icon to lock the timing at 12°
BTDC.