Pentair TRACETEK Operating Instructions

TRACETEK
TEST DEvIcE For TT-FFS ProbE

Operating instructiOns

PRODUCT CHARACTERISTICS
Weight
Light source
Battery information
Projected battery life
Recommended battery replacement interval
Duration of low battery signal
Maximum ambient temperature
Minimum ambient temperature
Operating Instructions
Follow the guidelines discussed in the flow chart sequence on page 2 to
evaluate the operational state of any TT-FFS Probe.
Note: A TT-ffS Probe with MC series metal connector can be con-
nected directly to the TT-ffS Probe Tester as shown in Photos 1 and 1A.
Photo 1
THERMAL BUILDING SOLUTIONS
Photo 1A
EN-TraceTekTTFFSprobetester-IM-H58496 04/16
GENERAL INfORMATION
Please read these instructions and keep them in a safe place. These
instructions must be followed carefully to ensure proper operation.
The TT-FFS Probe Tester is a battery powered device that provides the
capability of testing a TT-FFS Probe to determine whether it is functioning
properly. Designed for use in ordinary areas, the TT-FFS Probe Tester
is a hand held device used to evaluate the operational state of a TT-FFS
Probe. It produces flashing signals with bright red LEDs that identify
different operational conditions of the TT-FFS Probe.
The TT-FFS Probe Tester also monitors its battery voltage and produces a
special DOUBLE Flash signal when the batteries need replacing.
The TT-FFS Probe Tester utilizes the same cable connection hardware as
the TT-FFS Probe. When the TT-FFS Probe Tester is properly connected
to a TT-FFS Probe, the TT-FFS Probe Tester may produce a SINGLE
Flash signal, or a NO Flash signal, to indicate the operational state of the
TT-FFS Probe. Follow the specific steps described in these Operating
Instructions to determine the operational state of the TT-FFS Probe.
STORAGE
Keep the TT-FFS Probe Tester in a dry place that provides temperature
stability in between uses. Avoid impacts that might damage the device.
0.3 kg (0.7 lb) nominal
3 high intensity, high efficiency red LEDs
2 "AA" Alkaline Long Life
1 year – nominal
1 year or whenever low battery signal is detected
Minimum 30 days at 20°C (68°F)
40°C (104°F)
–20°C (–4°F)
Note: A TT-ffS Probe without metal connector (L series) can be
connected with the TT-ffS-ALLIGATOR4CLIP-MC cable end adaptor as
shown in Photos 2 and 2A. The 4 colored alligator clip wires should be
connected to the corresponding colored wires of the TT-ffS Probe.
Photo 2
Photo 2A
1 / 2