Page 1
IP Sur veillance AA-351/AA-352 Surveillance Power/Junction Box Installation Guide Rev.: 1.0...
Page 2
CAUTION: REFER SERVICING TO QUALIFIED SERVICE PERSONNEL. UNPACKING: Unpack carefully. Electronic components can be damaged if improperly handled or dropped. If an item appears damaged in shipment, place it properly in its carton and notify the shipper. IMPORTANT!: 1. The electrical connections and conduit installations shall be made by a certified electrician following local regulations.
Page 3
AM-21D, AM-21E, AM-314, AM-315, AM-414 Power box AA-351 Power box AA-352 Wiring Route your power wires through a 3/4" conduit into the power box. The wiring scheme is shown below. The power supply converts 115/230V power to the AC24V output to IP cameras.
Page 4
Introduction The power box can be mounted with the AM-314, AM315 pole-mount, AM-414 corner-mount bracket, or directed secured to a wall.
3/4” conduit The mounting hole definition is illustrated below. The same mounting hole pattern apply to all pole- mount and corner-mount brackets. Pole mount bracket: AM-314 AM-21D Box: AA-351 AA-352 AM-21E AM-718 Outdoor PoE switch: Speed Dome: AW-GEU-083A-240 SD9361/62/63/64/65/66 AW-GET-083A-120...
Page 6
If the power box is directly mounted to wall, drill holes in a diameter of 9.5mm or 3/8", and 4cm deep. Use the following mounting positions for the camera housings (via AM-21D and AM-21E). AM-21D AM-21E...