Initial Set-Up; Before The Dive - Sherwood maximus Owner's Manual

Your Sherwood regulator provides options for the attachment of accessories such as the
submersible pressure gauge or dive computer, the buoyancy compensator inflator air supply
and the alternate air source (octo).
Sherwood recommends that you consult your Authorized Sherwood Dealer to install these
accessories for you.
It is important to inspect the regulator before starting your dive trip and again just before you
enter the water. The pre-dive check should consist of at least the following steps.
1. Carefully inspect all hoses for signs of damage. This may require you to retract the
hose protectors at the ends of the hoses to examine the hose condition near the end
fittings. If the hose is damaged have your Authorized Sherwood Dealer replace it
before you dive.
2. Visually inspect the entire regulator for signs of damage. If in doubt ask your
Authorized Sherwood Dealer to assist you in performing this examination.
3. Connect the regulator to a pressurized cylinder and press the purge button several
times to confirm air flow. Take a few test breaths. The effort to breathe should be
minimal. If there is an unusual breathing resistance, have your regulator checked by a
professional instructor or by your Authorized Sherwood Dealer before attempting to
enter the water.
8
INITIAL SET UP

BEFORE THE DIVE

WWW.SHERWOODSCUBA.COM