How To Use The Buttons; Auto Operation; Cooling/Heating/Fan Operation; Dehumidifying Operation - Pioneer RG52F3JBGEFU1 Owner's Manual

－
厂
D
D
＠
三
＠
三
G
声
至二
I

How to use the buttons !

,

Auto operation

Ensure the unit is plugged in and power is
available. The OPERATION indicator on the
display panel of the indoor unit starts f lashing.
1. Press the MODE button to select Auto.
2. Press the UP/DOWN button to set the
©
desired temperature. The temperature can
°
be set w ithin a range of 62
increments.
3. Press the ON/OFFbutton to start the air
conditioner.
NOTE
1. In the Auto mode, the air conditioner can logically
choose the mode of Cooling, Fan, and Heating
by sensing the difference between the actual
ambient room temperature and the setti n g
temperature on the remote controller.
2. In the Auto mode, you can not switch the fan speed.
It has already been automatically controlled.
3. If the Auto mode is not comforlable for you , the
desired mode can be selected manually.
Cooling /Heating/Fan operation
Ensure the unit is plugged in and power is
available.
1. Press the MODE button to select COOL,
HEAT(cooling & heating models only) or
FAN mode.
2. Press the UP/DOWN buttons to set the
desired temperature. The temperature can
©
°
be set within a range of 62 F- 86
increments.
3. Press the FAN button to select the fan speed
in four steps-Auto, Low, Med,or High.
4. Press the ON/OFF button to start the air
conditioner.
NOTE
In the FAN mode, the setti n g temperature is not
displayed in the remote controller and you are not
able to control the room temperature either. In this
case, only step 1, 3 and 4 may be performed.
鱼
°
F- 86 F in俨F
° °
F in 1 F

Dehumidifying operation

D
Ensure the unit is plugged in and power is
available. The OPERATION indicator on the
display panel of the indoor unit starts flashing.
1. Press the MODE button to select DRY mode.
2. Press the UP/DOWN buttons to set the
desired temperature. The temperature
＠
can be set within a range of 62
°
in 1 F increments.
3. Press the ON/OFF button to start the air
conditioner.
NOTE
In the Dehumidifying mode, you can not switch the
fan speed. It has already been automatically controlled.

Adjusting air flow direction

Use the SWING令and SWING 41> buttons to adjust
the desired airflow direction.
1. When push the SWING令button, the horizontal
louver changes 6 degree in angle for each push.
If pushing more than 2 seconds, the louver
will automatically swing up and down.
2. When push the SWING 41> button, the vertical
louver changes 6 degree in angle for each push
If pushing more than 2 seconds, the louver
will automatically swing left and right.
NOTE: When the horizontal/vertical louver swing
or move to a position which would affect
the cooling or heating effect of the air
conditioner, it would automatically change
the swing/moving direction.
曼
°
F- 86午