Yamaha WX-030 Supplement Manual

You can use two WX-030 to reproduce stereo sound by setting each speaker as a right or left
speaker. Set the left and right speakers separately by following the steps below.
Left
speaker
WX-030
Setting/Playing back music
A
Connect each WX-030 to the same network by
using the dedicated app "MusicCast
CONTROLLER".
When the WX-030 is linked to other MusicCast unit,
cancel the link by using the dedicated app "MusicCast
CONTROLLER".
B
Tap (power)/CONNECT of each unit to set
them to standby mode.
C
Tap and hold the following together for
3 seconds to set the left/right speakers.
1 For setting the left speaker:
Indicators light from right to left repeatedly (refer to
of the table on the right), and the unit enters pairing
standby mode.
2 For setting the right speaker:
Indicators light from left to right repeatedly (refer to
of the table on the right), and the units start pairing.
After paring is completed, the indicators light from the
center to both sides (refer to
and all indicators return to the normal status.
D
Use the dedicated app "MusicCast
CONTROLLER" to play back.
y
• You can check which speaker is the left or right speaker with
the dedicated app "MusicCast CONTROLLER" (Indicators
light as or of the table on the right).
• In Stereo Pair mode, you can operate one speaker to
simultaneously turn off both speakers or adjust the volume
of both speakers.
Note
The Stereo Pair setting remains even if the speakers enter
standby mode or the power cable is unplugged and plugged
again.
Right
speaker
WX-030
and
and
of the table on the right),
Supplement for Stereo Pair
Note
• To use the Stereo Pair function, you need two WX-030.
• Before setting the Stereo Pair, update the dedicated app
"MusicCast CONTROLLER" and the firmware of both units
to the latest version (refer to the owner's manual).
• Stereo Pair function does not support AirPlay.
• Stereo Pair is available only when the Network Standby
mode of the unit is enabled.
Canceling Stereo Pair
Tap and hold (or
speaker together for 3 seconds.
Indicators light from both sides to the center (refer to
of the table on the bottom) and Stereo Pair will be
canceled.
Note
• The Stereo Pair can be canceled only during standby mode.
• If you cancel Stereo Pair with one of the two speakers, the
other one will be canceled automatically.
• If one of the two speakers is disconnected from the network
when canceling the Stereo Pair, cancel Stereo Pair on each
speaker.
Indicator display during the Stereo
Pair
Stereo Pair
status
Left speaker
Start Pairing/
Checking the
Left and Right
Speaker
Right-to-Left
Pairing
Completed
Canceling
Stereo Pair
) and on either
Indicator display
Right speaker
Left-to-Right
Center to both sides
Both sides to center
© 2015 Yamaha Corporation
Printed in China ZT49720
EN