Sensor Alarm; Record Setting - Sylvania SY164 Instruction Manual

Sensor Alarm

Sensor Alarm
This submenu allows you to configure the recording parameters under the Alarm condition.
1. BUZZER - Select the buzzer ON or OFF when the alarm
is activated
2. ALARM RECORD DURATION - Selects how long the
DVR will automatically record after an alarm is triggered.
Available duration times are: OFF, 05, 10, 15, 20, 25, 30,
35, 40, 45, 50, 55, 60, 90, 120, 150, 180, 210 and 240
seconds
3. ALARM OUTPUT DURATION - Selects how long the
DVR will automatically record after an output alarm is
triggered. Available duration times are: OFF, CONT, 05,
10, 15, 20, 25, 30, 35, 40, 45, 50, 55, 60, 90, 120, 150,
180, 210 and 240 seconds
4. ALARM INPUT - Select the type of alarm input for each
camera, OFF, N/O (Normally Open) or N/C (Normally
Closed). The alarm inputs are set up at the back of the
DVR, labelled "SEN1 – SEN4" (Sensor 1 – Sensor 4)

Record Setting

This submenu allows you to set the Record parameters for your Hard Disk Drive. Use this section to configure your
record settings. The selected FPS and Quality will determine how long the DVR will record for.
1. RECORD MODE - Set to record a Full Screen or Quad screen
2. RECORD QUALITY - Sets the quality level of recording. Available settings are: NORMAL, HIGH, LOW. The default
setting is: NORMAL
NOTE:
Higher quality recording consumes more memory on your Hard Drive. Refer to the Recording Time (in
Hours) table on page 38 for the different recording speed associated with the type of setting that you
26
SENSOR / ALARM SETUP
BUZZER
ALARM RECORD DURATION
ALARM OUTPUT DURATION
ALARM INPUT
CAMERA 1
CAMERA 2
CAMERA 3
CAMERA 4
ON
10
OFF
OFF
OFF
OFF
OFF