Cleaning The Air Filter Element - Yamaha AG100FA Owner's Manual

PERIODIC MAINTENANCE AND ADJUSTMENT
sion.
1
2
1
3
2
4
1. Gasket
2. Transmission oil drain bolt
5
3. Install the transmission oil drain
bolt and its new gasket, and then
6
tighten the bolt to the specified
torque.
7
Tightening torque:
Transmission oil drain bolt:
8
23 Nm (2.3 m·kgf, 17 ft·lbf)
4. Refill with the specified amount of
9
the recommended transmission
oil, and then install and tighten the
oil filler cap.
Recommended transmission oil:
See page 9-1.
Oil change quantity:
0.70 L (0.74 US qt, 0.62 Imp.qt)
NOTICE
In order to prevent clutch slip-

page (since the transmission oil
also lubricates the clutch), do
not mix any chemical additives.
Do not use oils with a diesel
specification of "CD" or oils of a
higher quality than specified. In
addition, do not use oils labeled
"ENERGY CONSERVING II" or
higher.
Make sure that no foreign mate-

rial enters the transmission.
5. Start the engine, and then let it idle
for several minutes while checking
the transmission for oil leakage. If
oil is leaking, immediately turn the
engine off and check for the cause.
7-10

Cleaning the air filter element

The air filter element should be cleaned
at the intervals specified in the periodic
maintenance and lubrication chart.
ECA10452
Clean the air filter element more fre-
quently if you are riding in unusually
wet or dusty areas.
1. Remove panel B. (See page 7-7.)
2. Remove the air filter case cover by
removing the screws.
1
2
1. Air filter case cover
2. Screw
3. Pull the air filter element out, clean
it with solvent, and then squeeze
the remaining solvent out.
EAU21002
2