Oregon Scientific ESM200U User Manual page 13

CLEAR RECORD�
To clear records of TOTAL data (Cost �� Energy �� GHG):
. Press and hold �ET to enter Setting mode.
2. Press MODE repeatedly to navigate to sub setting
ACCU. Press �ET to enter.
3. Press ADJ��T to select RESET YES / NO.
4. Press �ET to confirm.
5. Press MODE repeatedly to navigate to END. Press �ET
to exit and return to COST display.
OR
• Press and hold MODE and �ET simultaneously (when
not in Setting mode).
Key tone confirms delete process is complete and
successful.
To clear all memory in main unit and return to default
settings:
• Press and hold �ET and RE�ET together.
RE�ET
Press RE�ET to restart the unit, main unit will search for last
transmitter received.
NOTE
Records of Total data (accumulated cost / energy /
greenhouse gas) is stored in memory.
TRO�bLE�HOOTING
PRObLEM �yMPTOM
Strange
readings
Strange
readings
High readings
"- - - -" Not
displayed synchronised
"0.00" Problem with
displayed the sensor

REMEDy
Set cost rate setting.
Check appliances are not
malfunctioning (turned off
by itself) as this could be
shown as a sudden drop in
electricity usage.
Check appliances have
been switched off if not
in use.
Press and hold CHECk on
remote transmitter.
Then, press and hold
�EARCH on the main unit.
If still unsuccessful, press
RE�ET on transmitter and
main unit.
Check sensor clamp has
been properly fitted and
closed.
Possible damage in the
sensor clamp. Replace
clamp with new one.