SonicWALL PRO 2040 Quick Start Manual page 6

Windows 98
1. From the Start list, highlight Settings and then select Control Panel. Double-click the Network icon in the Control
Panel window.
2. Double-click TCP/IP in the TCP/IP Properties window.
3. Select Specify an IP Address.
4. Enter 192.168.168.200 in the IP Address field.
5. Enter 255.255.255.0 in the Subnet Mask field.
6. Click DNS Configuration.
7. Type the DNS IP address in the Preferred DNS Server field. If you have more than one address, type the second
one in the Alternate DNS server field.
8. Click OK, and then click OK again.
9. Restart the computer for changes to take effect.
Accessing the PRO Series Management Interface
To begin the configuration of your SonicWALL, you must log into the SonicWALL using a Web
5
browser and the SonicWALL default LAN IP address, 192.168.168.168. Follow the instructions
below:
Alert! Please allow enough time for the SonicWALL to power up completely before attempting to log into the
Management Interface. It takes approximately three minutes for the SonicWALL to cycle completely. When
the Test light is no longer lit, the SonicWALL is ready for configuration.
1. Launch your Web browser.
Alert! Because you are temporarily disconnected from the Internet, you may receive an error message when
your Web browser first opens. This does not affect your installation process. Continue with the steps below.
2. Enter 192.168.168.168 in the Location or Address field.
SonicWALL Internet Security Appliance Quick Start Guide Page 5
Setup Continues