HP EliteDesk 800 Hardware Reference Manual page 35

13. Connect the external antenna (3) and screw into place (4).
14. If your model is an EliteDesk 800 95W, replace the fan assembly.
a. Set the fan assembly in place (1).
b. Tighten the three captive screws to secure the fan assembly to the chassis (2).
c. Connect the fan assembly plug to the system board (3).
15. Install the access panel.
For instructions on installing the access panel on a 35W model, see
●
the HP EliteDesk 800 35W on page
For instructions on installing the access panel on any other model, see
●
on page 11.
16. If the computer was on a stand, replace the stand.
13.
Installing the access panel of
Installing the access panel
Installing an external antenna 29