Table of Contents
Advertisement
Nothing displays
◆ Check that the battery has been charged and installed correctly.
◆ Check that the phone has been turned on (PWR key pressed for
more than one second).
You have entered a phone number, but the phone is not
dialing it.
◆ Have you pressed the SEND button?
◆ Is the cellular phone service currently available (SVC
displayed)?
◆ Are you accessing the right cellular network (if the phone is
programmed for dual network use)?
Your party cannot reach you.
◆ Is your phone turned on (PWR key pressed for more than one
second)?
◆ Are you accessing the right cellular network (if the phone is
programmed for dual network use)?
Your party cannot hear you speaking.
◆ Have you turned off the microphone (MUTE displayed)?
◆ Are you holding the phone close enough to your mouth? The
microphone is located at the bottom of the phone.
The phone starts beeping, and
◆ The battery is insufficiently charged. Replace the battery, and
recharge it fully until the lamp on the charger turns green.
86
flashes on the screen.
The audio quality of the call is poor.
◆ Check the signal strength indicator (
number of bars indicates the signal strength from weak ( ) to
strong (
).
◆ Try extending the antenna, moving the phone slightly, or moving
closer to a window if you are in a building.
No number is dialed when you recall a memory location.
◆ Check that the numbers have been stored correctly by using the
memory scan feature. (See page 32.)
◆ Re-store them in the memory, if necessary.
If the above guidelines do not enable you to solve the
problem, make a note of:
◆ The model and serial numbers of your phone
◆ Your warranty details
◆ A clear description of the problem
Then contact your local dealer or a SAMSUNG
Authorized Service Center.
) on the screen; the
87
Advertisement
Table of Contents
