Troubleshooting; Care And Maintenance; Specifications - Stanley HIDLISL Instruction Manual

OPERATINg INSTRUCTIONS
Operating the spotlight
IMPORTANT: While most HID spotlights take several minutes to achieve optimal brightness, this spotlight will light dimmer for
approximately 15 seconds, then brighten slightly to the correct brightness level. It was designed this way to function quickly; the
slight dimming is not a malfunction.
1. Disconnect from charger.
2. The on/off trigger is located in the front of the handle of the spotlight.
3. To turn the spotlight on, squeeze the trigger.
4. To turn off the spotlight, release the trigger.
Note:
The on/off trigger can be locked in the on position using the trigger lock switch on the side of the unit.
Operating the unit corded
Plug the double pin tip of the supplied 12 volt DC adapter into the 12 volt DC power and charging port. Insert the 12 volt DC plug
end into the accessory outlet of your vehicle or other 12 volt DC power source. Operate the unit as outlined in the previous section.
Using the carry lanyard (optional accessory)
The carry lanyard may be used to carry the unit or to hang it for storage. Always adjust the slide on the cords to keep the lanyard
secure around any supporting object.
CAUTION: TO REDUCE THE RISK OF PRODUCT DAMAGE:
• When light is hung by the carry lanyard, do not shake the spotlight or object that it is hanging from. Do not hang the spotlight
from any electrical wires or anything that it is not secure.
• Only use the carry lanyard for hanging this spotlight. The carry lanyard is not intended to support additional weight. Do not attach
or hang anything additional to the spotlight or risk of breakage may occur.

CARE AND MAINTENANCE

All batteries lose energy from self-discharge over time and more rapidly at higher temperatures. When the unit is not in use, we
recommend that the battery is charged at least every 3 to 6 months.
Never submerge the unit in water. If the unit gets dirty, gently clean the outer surfaces of the spotlight unit with a soft cloth moistened with
a mild solution of water and detergent.
There are no user-replaceable parts. Periodically inspect the condition of adapters, connectors and wires. Contact manufacturer to
replace any components that have become worn or broken.
Battery replacement/disposal
BATTERY REPLACEMENT
The battery should last the service life of the unit. Contact manufacturer for any information you may need.
SAFE BATTERY DISPOSAL
Contains a lithium-ion battery, which must be disposed of properly. Recycling is required, contact your local
authority for information. Failure to comply with local, state and federal regulations can result in fines,
or imprisonment.
Contact your local waste management authority to dispose of this product.
WARNINGS:
• Do not dispose of the battery in fire as this may result in an explosion.
• Before disposing of the battery, protect exposed terminals with heavy-duty electrical tape to prevent shorting (shorting can result
in injury or fire).
• Do not expose battery to fire or intense heat as it may explode.
12 volt DC Adapter plug fuse replacement
The fuse in the plug end of the 12 Volt DC Adapter protects the adapter' s charging circuit. If the 120 Volt AC Adapter operates, but the DC
charging adapter does not, then this fuse may be opened (blown).
To replace the fuse:
1. Unscrew the end cap of the DC plug (counterclockwise).
2. Remove spring center contact and fuse.
3. Check fuse with a continuity checker.
4. If blown, locate a replacement 5 amp fuse.
5. Replace the fuse, spring, contact and end cap.
6. Screw end cap clockwise until it is finger tight – DO NOT OVER-TIGHTEN.
7. Test for proper operation of the 12 volt DC adapter.

TROUBLESHOOTINg

The battery/charge status LED indicator does not light when charging
1. Check connection to the AC-to-DC charging port or the 12 Volt DC Power and Charging Port.
2. Check connection to AC or DC power source.
3. Confirm there is a functioning AC or DC current.
4. Check that the fuse in the 12 Volt DC Adapter is not blown.
Unit will not operated in corded mode
1. Check the connection to the 12VDC Power and Charging port.
2. Check the connection to the DC power source.
3. Confirm there is a functioning DC current.
4. Check to see if the fuse of the 12 Volt DC Charging Adapter is open (blown). Replace, if necessary, following the directions
given in the "Maintenance" section of this manual.
5. The voltage of the vehicle battery (or other 12 volt DC source) may be low, activating the low voltage protection. In this case,
the battery and charging status LED indicator will alternately flash red and green.
Unit will not operate
1. The battery may be completely discharged. Charge the unit following the directions in this manual.
The manufacturer warrants this product against defects in materials and workmanship for a period of ONE (1) YEAR from the date
of retail purchase by the original end-user purchaser ("Warranty Period").
If there is a defect and a valid claim is received within the Warranty Period, the defective product can be replaced or repaired in the
following ways: (1) Return the product to the manufacturer for repair or replacement at manufacturer' s option. Proof of purchase
may be required by manufacturer. (2) Return the product to the retailer where product was purchased for an exchange (provided
that the store is a participating retailer). Returns to retailer should be made within the time period of the retailer' s return policy
for exchanges only (usually 30 to 90 days after the sale). Proof of purchase may be required. Please check with the retailer for their
specific return policy regarding returns that are beyond the time set for exchanges.
This warranty does not apply to accessories, bulbs, fuses and batteries; defects resulting from normal wear and tear, accidents;
damages sustained during shipping; alterations; unauthorized use or repair; neglect, misuse, abuse; and failure to follow
instructions for care and maintenance for the product.
This warranty gives you, the original retail purchaser, specific legal rights and you may have other rights which vary from state to
state or province to province. This product is not intended for commercial use.

SPECIFICATIONS

PLEASE
Spotlight
Bulb:
Battery:
RECYCLE
120 Volt AC Adapter
Charger:
12 volt DC Adapter (optional accessory)
Voltage:
DC Plug Fuse:
20 watt HID bulb
Lithium-Ion, 11.1 V DC
UL Listed Class 2, 12 volts DC (500mA)
12 volts DC
5A