Technical Specifications - Samsung SW-232 User Manual

Problem
When the MPEG software Adjust the size of the replay screen.
plays a Video CD, the
After checking the display resolution, adjust it,
pictures are not regular and
if necessary.
the running speed is too slow.
The Disc is not in message is The computer may not recognize the disc if you
start playback too quickly after inserting the disc.
displayed even though a disc
Open and close the disc compartment and try again.
has been inserted.
Clean the disc and try again.
The CD-R/RW drive is not The interface mode of the sound card is AT-BUS.
You must therefore connect the CD-R/RW drive to
detected after it is connected
the IDE port on the PC mother board, rather than
to a sound card.
to the sound card, or install an E-IDE compatible
sound card.
IN CD has the Formatted Right-click the mouse on TRAY ICON (right side of
the menu bar at the bottom of the monitor) and then
Disc Eject function.
select "Eject" to take the CD out.
Select the drive where the disc is inserted from
Windows Explorer.
Right-click the mouse and select "Eject" to take
the CD out.
When recording NERO, This seems to occur when you select the recording
function as the system selects "Image Recorder"
it will be recorded not on a
instead of SW-232.
CD but a form of image file.
In this case, select a recorder from the menu items
at the upper part of NERO and then select SW-232
from the Recorder Selection window.
When installing the recording software, try not to
install the software before the ROM drive as this
makes the Image Recorder selected.
The Recorder cannot Use the firmware automatic upgrade function
available at the ODD service website to download
recognize the disc.
the newest firmware and then reinstall the recording
software which is included in the bundle.
- www.samsungodd.com
- www.samsungelectronics.com
16
Meaning / Solution

Technical Specifications

SAMSUNG continually strives to improve its products. Both the design specifications
and these user instructions are thus subject to change without notice.
ITEM
Disc types supported CD-DA, CD-ROM mode 1, CD-ROM XA mode 2, Form 1,
DISC
in read mode Form 2, CD-Plus, CD-Extra, Photo-CD (Single, Multi-session),
Video CD ready, Enhanced CD, CD-I/Fmv, CD-R, CD-RW,
CD-TEXT
Disc types supported
CD-R, CD-RW
in write mode
Erasing disc types
CD-RW
Disc diameter
120 mm or 80 mm
Recording CD-R : 600 KB/sec. (4X),
Data transfer rate
DRIVE
PERFORMANCE
CD-R W : 1500 KB/sec. (10X), 600 KB/sec. (4X),
Reading CD: CAV 40 Access Time CD-RW : CAV 32 Access Time
PIO Mode 4:16.6MB/sec,
Multiword DMA mode 2:16.6MB/sec
Access time (typical) 110ms (typical)
Data Buffer
8MB
Laser Semiconductor laser
Slide mechanism Stepping motor
Spindle motor Brushless motor
Load mechanism Tray. DC motor (Soft Eject).
Mode 1: 1 block/10
ERROR RATE
Eject button
Auto eject or Auto inject
FRONT PANEL
Indicator Play / Read (GREEN) Record (RED), Operation LED
Headphone output
Stereo mini-jack (Ø 3.6 mm) 0.65±20% (vrms) 33Ω
Volume control Dial type
Required power +5 VDC: 1.5 A (max.), +12 VDC: 1.5 A (max.)
REAR PANEL
Interface connector ATAPI (E-IDE)
Audio output Line out 0.75±20% (vrms) : 47KΩ
Jumper block Device configuration jumper
Operations Temperature:
OPERATING
ENVIRONMENT
Storage Temperature: -25~55°C
Dimensions 148.2 (W) x 42 (H) x 184 (D) mm (including bezel)
GENERAL
Net weight
765 g
MTBF
RELIABILITY 125,000 POH(Duty 20%)
17
SW-232
1,200 KB/sec. (8X),
1800 KB/sec. (12X), 2,400 KB/sec. (16X),
3600 KB/sec. (24X), 4,800 KB/sec. (32X),
, Mode 2: 1 block/10
12 9
5~45°C Humidity: 10~80%
Humidity: 10~90%