Table of Contents
Advertisement
HCD-EX100
ADJUSTMENT OF CAM PHASE
Cam
Boss
Insert the cam so that the boss touches the SW lever
at the left shown in the figure.
With the phase adjusted, attach the parts using the following procedure.
STEP1
Insert the boss of the slider (3) in the groove of
the cam.
STEP2
Set the mecha cover to the groove
on the slider (3) and attach.
Screw
(BVTP2.6x8)
Cover, mechanical
Groove of slider (3)
4
Downloaded from
www.Manualslib.com
SERVICING NOTE
Absorber
SW lever
Note : Set the slider (1) in this location
before inserting the cam.
Slider (3)
Boss
Cam
Screw
(BVTP2.6x8)
manuals search engine
SECTION 1
Absorber
SW lever
Rotate the cam in the arrow direction, and adjust the
phase until the boss touches the SW lever shown in
the figure.
STEP3
Insert the boss of the lever (1) in the hole of the
slider (3) and attach.
Lever (1)
Boss
Hole of slider (3)
STEP4
While bending the slider (2) slightly in the arrow
direction, insert it in the groove of the guides (L)
and (R) and attach.
Slider (2)
Guide (R)
Cam
Boss
Lever (1)
Boss
Screw
(PTTWH2.6x8)
Boss (Four point)
Guide (L)
Advertisement
Table of Contents
