Standard Horizon QUANTUM AIS GX6000 Owner's Manual page 71

2. Rotate the DIAL/ENT knob to select "MANUAL", then
press the [SELECT] soft key.
3. Rotate the DIAL/ENT knob to select the first number
of the MMSI (nine digits) which you want to contact,
then press the [SELECT] soft key to step to the next
number.
4. Repeat step 3 to set the MMSI number.
If a mistake was made entering in the MMSI number, rotate the DIAL/ENT
knob to select "←" or "→", press the [SELECT] soft key until the wrong
character is selected, then perform step 3.
5. When finished entering the MMSI number, press the [FINISH] soft key.
6. Press the [YES] soft key to transmit the position
request DSC call.
7. When the GX6000 receives the position from the
polled vessel it is shown on the radio display.
8. Press the [QUIT] soft key to return to radio operation.
The received position from the polled vessel can be transferred to a
GPS chart plotter via NMEA DSC and DSE sentences.
10.6.3 Receiving a Position Request
1. When a position request call is received from another
vessel, a ringing sound will be produced, and the
display will be as shown in the illustration at the right.
2. Press any key to stop the alarm.
3. To send your vessel's position to the requesting
vessel, press the [REPLY] soft key.
Or to exit from position request display, press the
[QUIT] soft key.
NOTE
69