Table of Contents
Advertisement
Do not hit or strike glass. Do not operate this appliance if the glass is broken or cracked. Replacement of the
glass should be done by a licensed or qualified service person.
1. Remove the Face Assembly
Lift the face assembly upward and pull away.
2. Remove the Glass
See Figure 53, page 35.
3. Inspect the Log Set
The log set is shipped in one piece and should look
similar to that in Figure 40.
4. Place the Rock Wool
Place a small amount of 1/2 in. diameter pieces
(dime-size) of rock wool on the burner pan so that the
rock wool touches, but does not cover, the holes in
the burner pan. See Figure 41. This will provide the
"glowing embers" look. It is not necessary to use the
entire bag. Save the remainder for future use.
Figure 40 - MAX60 Gas Log Set
Rock Wool
Figure 41 - Placing the Rock Wool
28
H. APPLIANCE PREPARATION
WARNING - RISK OF CARBON MONOXIDE!
Never operate this appliance with the glass removed or not sealed.
WARNING - RISK OF CARBON MONOXIDE!
30484 Rev Q
MAXUS DIRECT VENT HEATER
5. Place the Lava Rock
This appliance is shipped with a refractory floor. You
may remove this floor and replace it with lava rock.
To remove the refractory floor, lift and slide it towards
you, bringing it out of the appliance. Install the lava
rock rail. There are hooks on the ends of the lava rock
rail. These hooks are to be inserted into the slots
located in the front of the appliance opening below
the front corners of the side refractories. Insert the
hooks into the slots. After insertion, slide the rail
towards the rear until it goes around the corner. Then
the front can be lowered. Please refer to Figures 42
and 43.
Figure 42 - The Lava Rock Rail
(Shipped with the appliance in the valve compartment.)
Figure 43 - Installing the Lava Rock Rail
09/04
Hide quick links:
Advertisement
Table of Contents
