Samsung GH68-15049A Quick Start Manual

Quick Start Guide
Bluetooth Mono Headset
WEP500
Get connected in 4 quick steps
Charge your headset
Put your headset in pairing mode
Turn on Bluetooth on your phone and
pair with headset

Test and use

Start here
Headquarters:
1301 East Lookout Drive Suite 150
Richardson, TX 75082
Internet Address:
http://www.samsungmobileusa.com/
accessories
Customer Care Center:
1-888-987-4357
Guide No.: GH68-15049A
07/2007. Rev. 1.1
Before using your headset
Thank you for purchasing the Samsung Bluetooth
Mono Headset WEP500. We hope you will be
delighted with its operation.
Take a moment before you get started to
familiarize yourself with your new headset.
Multi-Function
Secondary
button
microphone
Earpiece
Volume Up
button
Volume Down
Indicator light
button
Charging contact
Primary
microphone
Put your headset in
pairing mode
Before you can use your headset, you must pair it
with your phone.
• If you turn on the headset for the first time, it
proceeds into pairing mode immediately.
• If you have paired the headset with other Bluetooth
devices, make sure that the headset is off (see Turn
headset on/off on the reverse side of this guide).
Then press and hold the Multi-Function button until
the indicator light turns solid blue after blinking.
Check the accessories Check the accessories
Make sure you have the following items with your Make sure you have the following items with your
headset: headset:
Headset cradle, Adapter, User's Guide, Headset cradle, Adapter, User's Guide,
3 Earpiece Covers (Large, Medium, Small) 3 Earpiece Covers (Large, Medium, Small)
NOTE:
Your headset supports the Headset and/or Hands-Free
Profile(s).
Turn on Bluetooth on your
phone and pair with headset
1
Set your Bluetooth phone to discover the
headset by following your phone's user guide.
Typically, the steps involve going to the Settings,
Connection, or Bluetooth menu on your
phone and then selecting the option to discover
Bluetooth devices.
Your phone will find the Samsung WEP500
headset.
2
Select Samsung WEP500.
3
When the phone asks if you want to pair with it,
confirm by selecting Yes or OK.
4
Enter the headset passkey or PIN, 0000.
Charge your headset Charge your headset
3
Charge the headset's battery fully before using
the headset for the first time.
1
Put the headset in the supplied headset
cradle and close the cover.
4
2
Plug the adapter into the headset cradle's
socket.
Test and use
Your phone and headset are now paired and
ready to make and receive calls. To confirm
they are operating properly, make a call:
1
Place the headset over your ear.
See Wear the headset on the reverse
side of this guide.
2
On your phone, make a call to the number
you want.
3
If your phone and headset are successfully
paired, you will hear ringing on the headset.
After you have successfully paired your phone
and headset, you do not need to repeat these
initial setup steps each time you use the
headset.
Plug the adapter into the electrical outlet.
• Charge the headset until the red light on the
headset turns to blue.
• The headset will be fully charged in
approximately 2 hours.
Remove the adapter from the headset cradle.
NOTE:
The headset is not able to operate while charging.
Try to reconnect after charging is completed.
Using your WEP500
See Features and Functions Guide
on the reverse side of this guide
for information on using your
WEP500.