Table of Contents
Advertisement
9
Optional Equipment
FORCED AIR KIT (BLOTDL)
If you are installing the forced air kit, Model BLOTDL, see
the installation instructions provided with the kit for electri-
cal wiring requirements. The firebox must be connected to
main power supply at time of firebox installation. The blower
must be installed prior to the installation of the vent free
heater. The electrical connections must be made before
the firebox is framed and enclosed in the finished walls.
WARNING!
Electrical connections should only be performed
by a qualified, licensed electrician, main power
must be off when connecting to main electrical
power supply or performing service.
When installed, the blower must be electrically
grounded in accordance with local codes or in
the absence of local codes, with the National
Electrical Code ANSI/NFPA 70.
REFRACTORY
The LSTF36-B is shipped with factory installed refractory
panels. Once unit is in place, remove the shipping brackets
at the four corners of the floor brick.
NOTE: Brackets located at the top corners of the side panels
remain in place. If preferred, the fire brick can be removed
and the unit operated without any refractory panels.
Monessen • LSTF36-B Installation and Operating Manual • 4613-900 • Rev A • 01/18
ACCENT LIGHT KIT (MONALST)
If you are installing the accent light kit, Model MONALST,
see the installation instructions provided with the kit for
electrical wiring requirements. The firebox must be con-
nected to the main power supply at the time of firebox in-
stallation. The accent light must be installed prior to the in-
stallaton of the vent free heater. The electrical connections
must be made before the firebox is framed and enclosed
in the finished wall.
OPTIONAL DOOR KIT (DLR36B)
If you are installing the optional door kit, see the installa-
tions instructions provided with the kit.
Brackets to be removed before operation
Figure 9.1 Remove Brackets
19
Advertisement
Table of Contents
