Installing A Sixth Hdd - Acer Altos R720 Series User Manual

62
5 Slide the tape drive assembly into the combined tape drive or sixth
drive bay until the carrier clicks into place.
6 Plug the data cable to the rear of the tape drive.
7 Connect the other end of the data cable to the data cable
connector on the rear of the backplane board.
8 Plug the power cable to the rear of the device.
9 Connect the other end of the power cable to the power cable
connector on the rear of the backplane board.
10 Observe the post-installation instructions described on page 36.

Installing a sixth HDD

Caution! Before installing a sixth HDD into the server, make sure
a tape drive is not installed or occupying the sixth drive bay.
To install a sixth HDD:
1 Observe the ESD precautions and pre-installation instructions
described on page 35.
2 Using a long screwdriver, push the tape drive filler panel out from
the inside of the chassis.
3 System upgrade