S1500 / S2000 Features 2 Guided Tour 3 Front Panel 3 Rear Panel 4 Setting Up and Using Your S1500 / S2000 5 The S1500 / S2000 Protection Circuitry 6 Bridged and Parallel Modes 7 S1500 / S2000 Connections 8 Specifications 10 Produced by On The Right Wavelength for Samson Technologies Corp.
LED meters, and Protection LEDs. In these pages, you’ll find a detailed description of the many features of the S1500 / S2000 power amplifier, as well as a guided tour through its front and rear panels, step-by-step instructions for its setup and use, and full specifications.
The Samson S1500 / S2000 power amplifier utilizes the latest technology in professional power amplifier design. Here are some of its main features: • Power to spare - In the S1500, each channel delivers 750 watts of power into 4 ohms. In the S2000, each channel delivers 1000 watts of power into 4 ohms.
2: Power LED - Lights whenever the S1500 / S2000 is powered on. 3: Protection LED - This goes on for approximately five seconds whenever the S1500 / S2000 is powered on and then turns off (you’ll hear a “click” when it does so). The Protection LED will also light when overheating or other severe problems occur (see page 6 in this manual for more information).
Protection LED will go off (you’ll hear a click when this occurs). 7. Apply an input signal to the S1500 / S2000 at or about 0 dBu (if sending signal from a mixer, drive the output meters at approximately 0 vu). While the input signal is present, slowly raise the Channel Input controls until the desired sound level is achieved.
The S1500 / S2000 Protection Circuitry As noted in the “Guided Tour” section of this manual, the S1500 / S2000 front- panel Protection LED indicates the activity of the relay speaker connection circuitry. When the Protection LED is lit, this circuitry is active, and all connected...
1500 watt output into a single 8 ohm channel (in the case of the S1500) or a true 2000 watt output into a single 8 ohm channel (in the case of the S2000).
S1500 / S2000 Connections The illustrations on these two pages show the required interconnections when using the S1500 / S2000 in Stereo, Bridged and Parallel modes. Wiring for Speakon™ connectors (shown on the right) is indicated where appropriate. Stereo Mode: (two or four speakers)
Page 11
CH 1 (4 ohm min) (4 ohm min) Using the S700 / S1000 Link Connectors The illustration belows shows how multiple amplifiers can be interconnected using the S700 / S1000 link connectors. S1500 / S2000 Connections SAMSON MMPL2242 Speakon™ wiring: MPL2242...