Delta Subframe Preparation - Quicke Q20 Technical Manual

Installation

Delta subframe preparation

Consult both the safety and the installation instructions
before beginning any installation.
Before you begin to install the Subframe, ensure that you
are equipped with all of the proper tools and parts required
to attach the subframe to the tractor.
If any defect of the Subframe material, workmanship or
mounting is observed, contact Alo technical support. If the
Subframe does not fit properly, this issue should be addres-
sed immediately so that we are made aware of the potential
problem, and are able to instruct you on how to proceed.
Before mounting either of the latest loader ranges from
Quicke or Trima to the new Delta™ subframe, you must
carry out the following procedure.
All paint must be removed from the machined surfaces:
All paint must be removed from the machined surfaces:
A. Machined Saddle
B. Front Face and Lip
C. Loader
Remove all paint from tractor casting, and any excess paint
from subframe to ensure a secure contact. A chasing tap
may be required to clean out the tractor casting.
If a bolt will not start into its designated hole, check that the
hole is clean and free from paint. Also, make sure that the
bolt is being used in the correct hole. If there are any
problems screwing in the bolt, DO NOT attempt to force it
in; this could strip the hole of its threads.
Use an overhead hoist to raise the Subframe up to the
tractor. Be careful to protect the tractor hood and platform
from damage.
Start some of the bolts into the tractor. Once you are sure all
of the bolts will thread into their proper holes, begin
tightening the bolts so that they will support the Subframe.
4:2 2005-09