944
Tolerances and wear limits
Engine, removing and installing (manual transmission)
Hydraulic engine mounts, removing and installing
Checking hydraulic engine mounts
Checking and adjusting tension of Poly-rib belt for
alternator and compressor
Checking adjustment of compensating shaft
Checking and adjusting tension of the power pump belt
Checking and adjusting toothed belt tension - compensating shafts
Checking and adjusting toothed bert tension - compensating shafts (idler pulley with
slot)
Installing toothed belt - compensating shaft
Application - assembly stand VW 540 and engine holders 9127 and 9197
Identification of engine number on crankcase
Identification code, crankcase engine number
Crankcase and crankshaft, disassembling and assembling
Installing cover for the centrifugal compartment
Checking crankshaft bearing play
Identification code - upper and lower crankcase sections and compensating shaft
Aligning upper and lower crankcase sections
Installing crankshaft seal (flywheel side)
Flywheel and grooved ball bearing, removing and installing
Replacing setscrew (reference mark sensor)
Crankshaft dimensions - standard and machined
Pistons, disassembling and assembling con rods
Installing pistons with con rods
Installing pistons with con rods
Holding the flywheel for assembly work (with engine installed)
Table of contents
Printed in Germany - XXIV, 1993
Table of contents
volume I
Page
0.2
10 - 01
10 - 03
10 - 1
10 - 7
10 - 10
10 - 11
13 - 1
13 - 2
13 - 2a
13 - 3
13 - 6
13 - 11
13 - 13
13 - 14
13 - 14b
13 - 15
13 - 20 b
13 - 21
13 - 22
13 - 23
13 - 24
13 - 25
13 - 26
13 - 26a
13 - 27
13 - 28
13 - 29
13 - 31
13 - 32
13 - 34 b
13 - 35
13 - 37
1