Loading The Vehicle - Mercedes-Benz G 550 2015 Operator's Manual

Loading the vehicle

238
the multifunction display, the tire pressure
in one or more tires has dropped suddenly
and the tires must be checked.
If the wheel positions on the vehicle are
i
rotated, the tire pressures may be dis-
played for the wrong positions for a short
time. This is rectified after a few minutes of
driving, and the tire pressures are displayed
for the correct positions.
Restarting the tire pressure monitor
When you restart the tire pressure monitor, all
existing warning messages are deleted and
the warning lamps go out. The monitor uses
the currently set tire pressures as the refer-
ence values for monitoring. In most cases, the
tire pressure monitor will automatically
detect the new reference values after you
have changed the tire pressure. However, you
can also define reference values manually as
described here.
Set the tire pressure to the value recom-
X
mended for the corresponding driving sit-
uation on the Tire and Loading Information
placard on the driver's side
B-pillar ( page 232).
Y
Additional tire pressure values for different
loads can also be found on the tire pressure
table on the inside of the fuel filler flap
( page 232).
Y
Make sure that the tire pressure is correct
X
on all four wheels.
Make sure that the SmartKey is in position
X
2 in the ignition lock (
Press the = or ; button on the steer-
X
ing wheel to select the
Press the 9 or : button to select
X
Tire Pressure.
Press the a button.
X
The multifunction display shows the cur-
rent tire pressure for the individual tires or
Tire pressure will be displayed
the
X
If you wish to confirm the restart:
X
If you wish to cancel the restart:
X
page 103).
Y
Serv.
menu.
after driving a few minutes
sage.
Press the : button.
Use Current Pressures as New
The
Reference Values
message appears in
the multifunction display.
Press the a button.
Tire Press. Monitor Restarted
The
message appears in the multifunction dis-
play.
After driving for a few minutes, the system
checks whether the current tire pressures
are within the specified range. The new tire
pressures are then accepted as reference
values and monitored.
Press the % button.
The tire pressure values stored at the last
restart will continue to be monitored.
Loading the vehicle
Instruction labels for tires and loads
G
WARNING
Overloaded tires can overheat, causing a
blowout. Overloaded tires can also impair the
steering and driving characteristics and lead
to brake failure. There is a risk of accident.
Observe the load rating of the tires. The load
rating must be at least half of the GAWR of
your vehicle. Never overload the tires by
exceeding the maximum load.
mes-