Table of Contents Table of Contents ................................3 ............................4 Troubleshooting Guide ..............................7 Maintenance ................................... 8 General Maintenance ............................8 Replace Motor Brushes ............................8 Remove/Clean the Air Filter ........................... 9 Light ..................................9 Access Electrical Components ..........................9 .............................
Page 4
Width Length Height Weight Disk Size Motor RPM Tooling Assembly RPM Region Serial Number Power Input (High/Low Speed) (High/Low Speed)
Page 5
Safety GENERAL RULES FOR SAFE OPERATION Before use, anyone operating or performing maintenance on this equipment must read and understand this manual, as well as any labels pack- aged with or attached to the machine and its components. Read the manual carefully to learn equipment applications and limitations, as well as potential hazards associated with this type of equipment.
Page 6
Safety Safety GRINDER SAFETY GUIDELINES Dust Collection Grinding Beware of hidden obtrusions. Use with appropriate dust collecting system. Do not operate machine designed for use with a dust collector use on largely uneven surfaces. without the dust collector. Ensure dust collector is on and operating properly while grinding.
Maintenance GENERAL MAINTENANCE • • • FIG. 1 • REPLACE MOTOR BRUSHES Note: Do not remove the com- FIG. 2 mutator end bracket. Brushes can be installed through the openings in the bracket. Note: Brush shunt should be out of the way of the spring or brush holder. FIG.
Maintenance REMOVE/CLEAN THE AIR FILTER Removal and Installation Cleaning the Filter FIG. 5 LIGHT ACCESS ELECTRICAL COMPONENTS FIG. 6 FIG. 7 REPLACE MORFLEX COUPLERS FIG. 8 Note: You may need to remove (or replace, if needed) all of the See Tooling Assembly diagram. FIG.
Page 19
Parts List and Diagrams HANDLE ASSEMBLY (INTERNATIONAL ONLY) LABELS...
Page 20
Parts List and Diagrams WIRING DIAGRAM Helix Control Panel Schematic 12 AWG Black 12 AWG White 16 AWG Black 16 AWG White Motor Stop N-C 16 AWG Green Wire Number Motor Start N-O Safety Key N-C 6 Position Screw Final Assembly...
Warranty TO OBTAIN SERVICE CONTACT NATIONAL FLOORING EQUIPMENT, INC. TOLL FREE AT 800-245-0267 FOR A REPAIR AUTHORIZATION NUMBER. COD FREIGHT RETURNS WILL NOT BE ACCEPTED. FREIGHT COLLECT SHIPMENTS WILL NOT BE ACCEPTED. WARRANTY REPAIRS MUST BE ACCOMPANIED BY DATE OF PURCHASE RECEIPT AND A RETURN/ REPAIR AUTHORIZATION NUMBER.