Tips For Best Trimming Results; Decoritive Trimming; Maintenance Schedule - Ryobi Trimmer Operator's Manual

Ryobi outdoor trimmer user manual
Table of Contents

Advertisement

TIPS FOR BEST TRIMMING
RESULTS
Keep the cutting attachment parallel to the ground.
Do not force the cutting attachment. Allow the tip of
the line to do the cutting, especially along walls.
Cutting with more than the tip will reduce cutting effi-
ciency and may overload the engine.
Cut grass over 8 in. (200 mm.) by working from top
to bottom in small increments to avoid premature
line wear or engine drag.
Cut from left to right whenever possible. Cutting to
the right improves the unit's cutting efficiency.
Clippings are thrown away from the operator.
Slowly move the trimmer into and out of the cutting
area at the desired height. Move either in a forward-
backward or side-to-side
motion. Cutting shorter
lengths produces the best results.
Trim only when grass and weeds are dry.
The life of your cutting line is dependent upon;
Following the previous trimming techniques
What vegetation is being cut
Where it's being cut
For example, the line will wear faster when trimming
against a foundation wall as opposed to trimming
around a tree.
DECORATIVE
TRIMMING
Decorative trimming is accomplished
by removing all
vegetation around trees, posts, fences, etc.
Rotate the whole unit so that the cutting attachment is at
a 30 ° angle to the ground (Fig. 10).
NOTE: Some maintenance
procedures may require
special tools or skills. If you are unsure about
these procedures take your unit to an authorized
service dealer.
MAINTENANCE
SCHEDULE
These required maintenance
procedures should be
performed at the frequency stated in the table. They
should also be included as part of any seasonal tune-up.
WARNING:
To prevent serious injury, never
I
do maintenance
or repairs with unit running.
I
Always do maintenance
and repairs on a cool I
unit. Disconnect
spark plug wire to ensure
the unit will not start.
FREQUENCY
MAINTENANCE
REQUIRED
REFER TO:
Before Starting Engine
Fill fuel tank with correct oil and fuel mixture.
Page 9
Every 10 Hours
Clean and re-oil air filter.
Page 16
Every 50 Hours
Check spark plug condition and gap.
Page 18
13

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents