Ryobi CS30 RY30020A, SS30 RY30040A, BC30 RY30060A Operator's Manual page 18

OPERATION
STARTING AND STOPPING
See Figures 21 - 23.
TO START A COLD ENGINE:
DO NOT squeeze the throttle trigger until the engine starts
and runs.
n Lay the trimmer on a flat, bare surface.
n PRIME - Press the primer bulb 7 times.
n SET the start lever to the START position.
n PULL the rope until the engine starts.
IGNITION
n Allow the engine to run for 15 seconds.
SWITCH
n Squeeze trigger lock and throttle trigger.
PRIMER BULB
NOTE: Squeezing the throttle trigger releases the start lever
to the RUN position.
TRIGGER LOCK
TO START A WARM ENGINE:
PULL the rope until the engine starts.
TO STOP THE ENGINE:
THROTTLE TRIGGER
Press and hold the switch in the stop " " position until
Fig. 22
the engine stops.
START POSITION
IGNITION
START LEVER
SWITCH
TRIGGER
LOCK
THROTTLE
TRIGGER
Fig. 21
RUN POSITION
START LEVER
Fig. 23
Page 18