OPERATION
STARTING AND STOPPING
See Figures 21 - 23.
PRIMER BULB
TO START A COLD ENGINE:
DO NOT squeeze the throttle trigger until the engine starts
and runs.
Lay the trimmer on a flat, bare surface.
PRIME - Press the primer bulb 7 times.
SET the start lever to the START position.
PULL the rope until the engine starts.
IGNITION
Wait 6-10 seconds, then squeeze the trigger to run.
SWITCH
NOTE: Squeezing the throttle trigger releases the start lever
to the RUN position.
TO START A WARM ENGINE:
TRIGGER LOCK
PULL the rope until the engine starts.
TO STOP THE ENGINE:
Press and hold the switch in the stop "
" position until
THROTTLE TRIGGER
the engine stops.
Fig. 22
START POSITION
IGNITION
SWITCH
TRIGGER
LOCK
START LEVER
THROTTLE
TRIGGER
Fig. 21
RUN POSITION
START LEVER
Fig. 23
18