Cleaning The Speedspool; Speedspool Replacement Parts - Ryobi 825r Operator's Manual

MAINTENANCE AND REPAIR INSTRUCTIONS

CLEANING THE SPEEDSPOOL

Cleaning the SpeedSpool
• To remove jammed or excess line,
®
• If the SpeedSpool becomes difficult to wind or
does not operate correctly when bumping the head
on the ground,
1. Hold the outer spool, and unscrew the bump knob
counterclockwise (Fig. 25).
Fig. 25
2. Pull out the bump knob, spring, and foam seal
(Fig. 23, Pg. 17).
3. Pull the inner reel with existing line from the outer
spool (Fig. 23, Pg. 17).
4. Remove any existing line from the inner reel before
cleaning. Remove any debris or grass from the knob,
spring, inner reel, and foam seal. Wash the inner reel
with warm soapy water (Fig. 26).
Inner Reel
Fig. 26
18
®
®
may be necessary,
5. Clean the shaft and the inner surface of the outer
spool. To clean the shaft underneath the plunger,
press down on the plunger (Fig. 27). Remove any dirt
or debris from the shaft.
Shaft
Plunger
NOTE: The inner reel must be totally dry before
reinstalling it into the outer spool. Do not
lubricate the inner reel or outer spool assembly.
6. Place the inner reel into the outer spool.
7. Place the bump knob, spring, and foam seal into the
inner reel (Fig. 23, Pg. 17).
8. Press the bump knob down and tighten clockwise.
9. Install new line as described in Line Installation for
®
the SpeedSpool Pg. 16.
®
SPEEDSPOOL REPLACEMENT PARTS
Replacement Line . . . . . . . . . . . . . . . . . . . . . . . . 181472
Replacement Line Cartridge . . . . . . . . . . . . . . . . 181460
Inner Reel Spring . . . . . . . . . . . . . . . . . . . . . . . . 181465
Foam Seal . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 181467
Inner Reel . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 181460
Bump Head Knob Assembly . . . . . . . . . . . . . . . . 181468
(Bump Head, Inner Reel, Spring, )
®
These SpeedSpool replacement parts can be
purchased from your local authorized dealer.
Fig. 27