Operating Instructions; Operating Click-Link System (790R) - Ryobi 780r Operator's Manual

OPERATING THE CLICK-LINK
SYSTEM - MODEL 790r
The model 790r Click-Link
use of these optional add-ons.
Blower/Vacuum . . . . . . . . . . . . . . . . . . BV720r
Cultivator . . . . . . . . . . . . . . . . . . . . . . . GC720r
Edger . . . . . . . . . . . . . . . . . . . . . . . . . . LE720r
Hedgetrimmer . . . . . . . . . . . . . . . . . . . HS720r
Snowthrower . . . . . . . . . . . . . . . . . . . . ST720r
Straight Shaft Trimmer . . . . . . . . . . . . . SS725r
Sweeper/Blower . . . . . . . . . . . . . . . . . . SB720r
Tree Pruner . . . . . . . . . . . . . . . . . . . . . . TP720r
Turbo Blower . . . . . . . . . . . . . . . . . . . . TB720r
WARNING: Read and understand
operator's manual for add-on prior
to operation.
Removing the Cutting Attachment
or Add-Ons:
1. Turn the knob counterclockwise to loosen
(Fig. 21).
2. Press and hold the release button (Fig. 21).
3. While firmly holding the upper shaft housing,
pull the cutting attachment or add-on
straight out of the Click-Link
(Fig. 22).
Installing the Cutting Attachment or
Add-Ons:
WARNING: To avoid serious
personal injury, shut unit off before
removing or installing add-ons.
NOTE: To make installing or removing the
add-on easier, place the unit on the
ground or on a work bench.
1. Turn knob counterclockwise to loosen
(Fig.21).
®
Click-Link Coupler
Knob

OPERATING INSTRUCTIONS

®
®
system enables the
®
coupler
Release Button
Guide Recess
Fig. 21
2. While firmly holding the add-on, push it
straight into the Click-Link
NOTE: Aligning the release button with the
guide recess will help installation
(Fig. 21).
®
Click-Link Coupler
Upper Shaft Housing Lower Shaft Housing
3. Turn the knob clockwise to tighten
(Fig. 23).
CAUTION: Lock the release button
in the primary hole and securely
tighten the knob before operating
this unit.
90˚ Edging Hole
CAUTION: The cutting attachment
and add-ons with the Click-Link
system are to be used in the primary
hole unless stated otherwise in the
specific add-ons operator's manual.
Using the wrong hole could lead to
personal injury, or damage to the
unit.
NOTE: For edging with Click-Link
lock the release button of the cutting
attachment into the 90° edging hole
or the 180° edging hole (Fig. 23).
®
coupler (Fig. 22).
Primary Hole
Release Button
Fig. 22
180˚ Edging Hole
Fig. 23
®
models,
Knob
®
17